Husqvarna AUTOMOWER 320 NERA Operator's Manual page 33

Message
Lifted
Trapped
Slipped
Collision
Alarm! Mower stop-
ped
Alarm! Mower was
moved
Alarm! Outside Geo-
Fence
Temporary problem
2071 - 001 - 29.03.2023
Cause
The lift sensor has been enabled because
the product has been lifted.
The product is blocked in a small area be-
hind a number of obstacles.
The product slips because there is an obsta-
cle.
The product slips because of wet grass.
The product has hit an obstacle and stopped
or the wheels cannot move on the wet grass.
The product slips because the slope is too
steep.
The product slips because the slope is too
steep when it follows the guide wire.
The body of the product cannot move freely
around its chassis.
The alarm was started because the product
was stopped.
The alarm was started because the product
was lifted.
The alarm was started because the product
was tilted.
The alarm was started because the product
was moved.
The alarm was started because the product
was outside the GeoFence.
Temporary electronic or firmware problem in
the product.
Action
Make sure that the body of the product body
can move freely around its chassis. Remove
or make an island around objects that can
cause the body to be lifted. If the problem
stays, speak to your authorized service cen-
ter.
Examine if there are obstacles which make it
hard for the product to move away from this
location.
Remove the obstacle.
Wait until the lawn is dry before you start the
product again.
Free the product and rectify the reason for
the lack of drive. If it is due to wet grass,
wait until the lawn has dried before using the
product.
Isolate the steep slope with boundary wire.
To put the boundary wire in a slope
Refer to
on page 14 .
Make sure that the guide wire is installed
diagonally in the slope. Refer to
boundary wire in a slope on page 14 .
Make sure that the body of the product can
move freely around its chassis. Examine that
the body of the product is correctly installed
and there is no dirt blocking it. If the problem
stays, speak to your authorized service cen-
ter.
Enter the PIN code to disable the alarm. The
settings for the alarm can be changed in the
Security menu. Refer to Alarm duration on
page 23 .
Update the firmware via FOTA. Restart the
product. If the problem stays, speak to your
authorized service center.
To put the
Troubleshooting - 33