Operation; To Set The Product To On; To Start The Product; To Park The Product - Husqvarna AUTOMOWER 320 NERA Operator's Manual

The most frequently used operation settings are
included in the Automower
®
Automower Access on page 6 . All operating modes are
available in the Automower

5.1 To set the product to ON

WARNING:
safety chapter before you use the product.
• Push the jog wheel for 3 seconds.
• Use the jog wheel to enter the PIN code.

5.2 To start the product

1. Push the STOP button.
2. Use the jog wheel to enter the PIN code.
3. Use the jog wheel to select the operating mode.
Operating modes - Start on page 25 .
Refer to
4. Push the START button.
Note:
If the product is parked in the charging station,
the product will start to operate when the battery is fully
Schedule settings is set for operation
charged and if the
Note:
The first weeks after installation the perceived
sound level when cutting the grass may be higher than
expected. When the product has cut the grass for some
time, the perceived sound level is much lower.
5.2.1 Operating modes - Start
Main area
•
• Secondary area
Override schedule
•
5.2.1.1 Main area
Use the operating mode
and charge automatically.
5.2.1.2 Secondary area
Secondary area operating mode to cut secondary
Use
areas. You must move the product manually between
the main area and the secondary area. The product cuts
for a selected period of time or until the battery is empty.
Note:
You must put the product manually in the
charging station to charge the product when it is in a
secondary area. The product will move out from the
charging station and stop when the battery is charged.
You must select an operating mode to start the product.
2071 - 001 - 29.03.2023
®
Access, refer to
®
Connect app.
Read and understand the
Main area for the product to cut

5 Operation

Note:
If you will cut the main area after the battery is
charged, set the product to
put the product in the charging station.
5.2.1.3 Override schedule
Use the operating mode
temporarily override the
days .
Note:
It is not possible to cut more than the maximum
cutting time for each day. Refer to
on page 6 .

5.3 To park the product

1. Push the STOP button.
2. Use the jog wheel to enter the PIN code.
3. Use the jog wheel to select the park mode. Refer
Operating modes - Park on page 25 .
to
5.3.1 Operating modes - Park
Park until further notice
•
Start on next schedule
•
Select duration
•
Park at maintenance point (EPOS
•
only)
5.3.1.1 Park until further notice
Use the operating mode
product to go back to the charging station. The product
will stay in the charging station until you select a new
operating mode.
5.3.1.2 Start on next schedule
Use the operating mode
product to go back to the charging station. The product
will stay in the charging station until the next
setting.
5.3.1.3 Select duration
The product goes back to the charging station and
stays for the selected park duration. Use the operation
selection to temporary stop an ongoing mowing cycle
and let the product to stay in the charging station.
5.3.1.4 Park at maintenance point (EPOS
only)
You can park the product at the maintenance point to do
maintenance on the product. The product is parked at
the maintenance point until you select a new operation
mode.
Main area mode before you
Override schedule to
Schedule settings for 24h or 3
Product description
™
installation
Park until further notice for the
Start on next schedule for the
Schedule
™
installation
Operation - 25