Invacare Xterra GT Service Manual page 87

ELECTRONICS
DETAIL “A”
RII Controller
Locknuts
Washer
DETAIL “C”
Connector
Controller
Connector
Tie-Wraps
Joystick
Mounting
Tube
NOTE:
1.The seat is removed for clarity.
2. The portion of controller cable located between
rear tie-wrap on motor mount plate and central tie-
wrap on rear seat frame tube MUST have enough
slack in it so as to allow full up and down travel of
motor during chair operation.
FIGURE 8 - REMOVING/INSTALLING MKIV-RII CONTROLLER
Part No. 1110516
DETAIL “B” - IDENTIFYING MKIV-
RII CONTROLLER CONNECTORS
Front
Shroud
Washer
RII Controller
Washer
Mounting Screws
(Torque to 40-in/lb.)
NOTE: View is top right side of chair.
Joystick
Tie-Wrap
87
Battery Wire Harness
Connector
Motor
Connector
Controller Connector
Lead for Joystick
DETAIL “D”
This area is to be used
to feed the controller
connector through
Wire Harness
Wrap
Tie-Wraps
Motor Cable
Tie-Wrap
Controller
Cable for
Joystick
See NOTE 2
SECTION 9
Power
Take-Off
Lead
Motor
Connector
XTERRA™ GT™