Invacare Xterra GT Service Manual page 58

SECTION 7
REMOVING/INSTALLING BATTERY TRAY (FIGURE 6)
REMOVING
1. Remove the batteries. Refer to REMOVING/INSTALLING BATTERIES in SECTION 8 of this
manual.
2. Remove the seat. Refer to REMOVING/INSTALLING SEAT FRAME in SECTION 6 of this
manual.
3. Remove the front shroud. Refer to REMOVING/INSTALLING FRONT AND REAR
SHROUD in this section of the manual.
4. Remove the controller. Refer to REMOVING/INSTALLING CONTROLLER in SECTION 9
of this manual.
5. Remove the wiring harness. Refer to REMOVING/INSTALLING WIRING HARNESS in
SECTION 9 of this manual.
6. Remove the right drive wheel to gain access to the rear mounting screw that secures the
battery tray in place. Refer to REMOVING/INSTALLING DRIVE WHEELS in SECTION 10 of
this manual.
7. Remove the two (2) mounting screws, washers, and locknut that secures the front of the
battery tray to the base frame.
8. Remove the mounting screw, washers, and locknut that secures the rear of the battery tray to
the base frame.
9. Remove battery tray from base frame.
INSTALLING
1. Secure the rear of the battery tray to the
base frame with the mounting screw,
washers, and locknut. Torque mounting
screw to 75-in./lbs.
2. Secure the front of the battery tray to the
base frame with two (2) mounting screws,
washers, and locknut. Torque mounting
screws to 75-in./lbs.
3. Install the right drive wheel. Refer to
REMOVING/INSTALLING DRIVE
WHEELS in SECTION 10 of this manual.
4. Install the wiring harness. Refer to REMOV-
ING/INSTALLING WIRING HARNESS in
SECTION 9 of this manual.
5. Install the controller. Refer to REMOVING/
INSTALLING CONTROLLER in SECTION
9 of this manual.
6. Install the front shroud. Refer to REMOVING/INSTALLING FRONT AND REAR SHROUDS
in SECTION 9 of this manual.
7. Install the seat. Refer to REMOVING/INSTALLING SEAT FRAME in SECTION 6 of this
manual.
8. Install the batteries. Refer to REMOVING/INSTALLING BATTERIES in SECTION 6 of this
manual.
XTERRA™ GT™
Mounting
Screw
Base Frame
Washer
Mounting
Screw
Battery Tray
FIGURE 6 -REMOVING/
INSTALLING BATTERY TRAY
58
BASE FRAME
Locknut
Part No. 1110516