Adjusting The Elevating Legrest Assembly - Invacare 9000 JYMNI PEDIATRIC Series Owner's Operator And Maintenance Manual

FRONT RIGGINGS
Bolt and
Locknut
STEP 1
STEPS 2 AND 3
Hinge
Legrest
Pins
Release
Handle
NOTE: Legrest J934A-14 shown. Legrest J934A in-
stall the same.
FIGURE 4 - ELEVATING LEGREST ASSEMBLY
INSTALLATION
ADJUSTING THE ELEVATING
LEGREST ASSEMBLY (FIGURE 5)
Raising Legrest Assembly
1. Assistant should grab hold of the lower legrest assembly
and raise elevating legrests until the desired height is
obtained.
Lowering Legrest Assembly
1. Support user leg with one (1) hand.
2. Perform one (1) of the following:
Model J934A Elevating Legrest -
A. Push release lever downward with other hand.
Model J934A-14 Elevating Legrest -
A. Pull release lever forward with other hand.
3. Gently, lower user leg down and rest against the
legrest.
Calfpad Assembly
Lower
Footrest
Assembly
Footplate
Hinge Plates
Elevating
Legrest
Assembly
Adjusting Calfpad (FIGURE 5)
1. Remove the elevating legrest assembly from the
wheelchair. Refer to ELEVATING LEGREST ASSEM-
BLY INSTALLATION in this procedure of the manual.
2. Remove the two (2) mounting screws and washers
securing the calfpad to the elevating legrest as shown
in DETAIL "A" of FIGURE 5.
3. Position the calfpad in one (1) of the two (2) height
positions.
4. Reinstall the two (2) mounting screws and washers
securing the calfpad to the elevating legrest. Securely
tighten.
Adjusting Height (FIGURE 5)
1. Adjust footrest to correct height by loosening the nut
and sliding the lower legrest assembly up or down until
desired height is achieved as shown in DETAIL "B" of
FIGURE 5.
2. Securely tighten nut.
DETAIL "A"
Calfpad
Washers
Mounting Screw
DETAIL "B"
Nut
Release
Lever
Lower Legrest
Assembly
FIGURE 5 - ADJUSTING THE ELEVATING LEGREST
17
PROCEDURE 3
Elevating
Legrest
Assembly
Release Lever
Lower
Legrest
Assembly
Nut
J934A-14
J934A
ASSEMBLY
F
R
O
N
T
R
I
G
G
I
N
G
S