Removing; Adjusting Elevating Legrest Assembly; Adjusting Footrest Height; Adjusting Calfpad - Invacare 9000 Topaz Owner's Operator And Maintenance Manual

Removing

1. Ensure the elevating legrest is in the lowered position. Refer to Adjusting Elevating
Legrest Assembly on page 27.
2. To release the elevating legrest
assembly push the legrest release
handle toward the inside of the
wheelchair (facing the front of the
wheelchair) and swing the legrest
assembly to the outside of the
wheelchair.
3. Lift the elevating legrest assembly off
the hinge pins.

Adjusting Elevating Legrest Assembly

Adjusting Footrest Height

NOTE: For this procedure, refer to FIGURE 4.4.
1. While sitting in the wheelchair, remove the two (2) bolts and locknuts securing the
lower footrest assembly to the elevating legrest assembly and move the lower footrest
assembly up or down until the desired height is achieved.
2. Secure the lower footrest assembly to the elevating legrest assembly with the two (2)
bolts and locknuts. Securely tighten.
3. Repeat steps 1-2 on remaining legrest assembly.

Adjusting Calfpad

NOTE: For this procedure, refer to FIGURE 4.4.
1. Remove the two (2) mounting screws securing the calfpad to the calfpad support of
the elevating legrest assembly.
2. Slide the Calfpad up or down until the desired position is obtained.
3. Secure the calfpad to the elevating legrest assembly with the two (2) mounting screws.
Securely tighten.
4. Repeat STEPS 1-3 to adjust remaining calfpad.
Part No. 1100869
SECTION 4—FRONT RIGGINGS
FIGURE 4.3 Installing/Removing Elevating
Legrest Assembly
27
9000 Topaz™Wheelchair