Invacare 9000 JYMNI PEDIATRIC Series Owner's Operator And Maintenance Manual page 20

PROCEDURE 4
NOTE: Make sure arm sockets sit flush against the
wheelchair frame.
5. Reinstall the hex screw and locknut that secure the
arm socket to the wheelchair frame and securely tighten.
6. Repeat STEP 5 for the opposite side of the wheelchair.
7. Refer to the following chart to determine which wheel
A
axle spacer is needed:
R
WHEELCHAIR
M
USING
S
Conventional Arms
Space Saver Arms
8. To install spacer, refer to REMOVING/INSTALL-
ING THE REAR WHEELS in PROCEDURE 6
of this manual.
9. Install the NEW arms onto the wheelchair. Refer to
REMOVING OR REPLACING ARMRESTS in this
section of the manual.
AXLE SPACER
LENGTH
5/8-inch
1/8-inch
Arm Socket (OUTSIDE of
20
SPACE SAVER ARM POSITION
Arm Socket
(INSIDE of
Wheelchair
Frame)
Locknut
Left Side of
Wheelchair
Frame
CONVENTIONAL ARM POSITION
Wheelchair Frame)
Locknut
Right Side of
Wheelchair
Frame
FIGURE 5 - CONVERTING FROM SPACE SAVER TO
CONVENTIONAL ARMS OR
CONVENTIONAL TO SPACE SAVER ARMS
(LIGHT WEIGHT)
ARMS
Hex
Screw
Wheelchair
Frame
Hex
Screw