Table of Contents
Advertisement
Loading a Database
In order to copy a configured database from MPU955 Admin Console onto the NSS Main
CPU, an administrator would need to use the Database Transfer section's "PUT to CPU"
option.
Although not mandatory, first saving the current database residing on the CPU would
allow for a manual comparison of any differences prior to loading the new database.
MPU955 Admin Console itself cannot detect differences. (Unless this is a first time
operation.)
Putting a configuration database onto the NSS CPU will overwrite its
entire existing database. It is recommended that you save the database
currently running on the Main CPU under a distinctive name before
loading a new database.
The following instruction will guide you through loading a database from MPU955
Admin Console to the CPU. See the Getting the Current Database section on page 25 to
save the database that is currently loaded in the CPUs.
1. Select the name of the database to load by clicking on the .adm file name
2. From the drop-down menu, select the proper CPU
For a redundant CPU system, you must load the database onto both CPUs to ensure they
are each using the same configuration.
For single CPU systems, choose 01A.
3. Click the "PUT to CPU" button - the right button under the Database
Transfer section
Configuration
26
Advertisement
Table of Contents
