Panasonic WJ-MPU955 User Manual page 135

Admin console
Hide thumbs Also See for WJ-MPU955:
Table of Contents

Advertisement

E N C O D E R
F i e l d D a t a
Port Description: Specifies a local control port for the device.
Validation: decimal format, 1 - 1024
Default Setting: Automatically assigned.
Note: This port number is the same as the port number of the CAMERA page, and it is necessary to
associate it.
Audio Description: Specifies the audio mode for the device.
Validation: 0 = OFF, 1 = ON
Default Setting: 0
Description: Specifies the video stream classification.
Video & Audio
Encryption
Validation: 0 = No Scramble, 1 = Scramble
Default Setting: 0
Encryption Key Description: Specifies the encryption key number. This is effective only when Video & Audio
Encryption is 1.
Validation: hexadecimal numeral, 00 -- FF
Default Setting: 0
TOS Description: Specifies a TOS in IP message header
Validation: 0 - 7
Default Setting: 0
TTL Description: Specifies a TTL in IP message header
Validation: hexadecimal numeral 0x00 - 0xFF
Default Setting: hexadecimal numeral 0F
Dynamic Range Description: Specifies a dynamic range for a camera.
Validation: 0 = Normal, 1 = Wide, 2 = Super wide
Default Setting: 0
Watermark Description: Specifies a watermark mode.
Validation: 0= Disable, 1 = Enable
Default Setting: 0
Watermark Value Description: Specifies a watermark value. This value only applies when the watermark mode is
set to enable.
Validation: 0 - 7
Default Setting: 0
GOP Description: Specifies GOP length in picture frames.
Validation: decimal format, 15 - 45
Default Setting: 15
Stream Format Description: Specifies the video stream format.
Validation: 0 = MPEG2, Other - Not defined
Default Setting: 0
Cam Type Description: Specifies a camera to control from a controller.
Validation: 0 = coaxial camera connected to encoder, 1 = RS485 camera connected to RS485
Data Port of encoder
Default Setting: 0
Note: Since only one RS485 camera is able to connect to each encoder, only one to the value 1
is effective in the same Device ID.
When 1 is set, communication setting between camera and an encoder is in RS485 Data Port.
Appendix A
131

Advertisement

Table of Contents
loading

Table of Contents