Table of Contents
Advertisement
ISM R
B
(ID 1)
ADIO
OARD
3. ISM Radio Board (ID 1)
Plug the ISM radio into the I/O base board with the U.FL antenna connector closest to the SMA connectors. Typically, users will not need to
adjust the DIP switch settings on the physical radio modules.
For the DXM1200 models, set the radio options using the LCD menu.
Button Operation
For DXM models without a LCD display, use the button to bind the ISM radio. For models with a LCD display, use the ISM menu to bind the radio.
LED Operation
The LED located on the ISM radio module indicates power and communications traffic. ISM board LED operations also display on the LED on the right side of
the I/O base board.
•
Solid green DX80 ISM radio LED indicates power.
•
Flashing green MultiHop ISM radio LED indicates operation.
•
Red and green combined: Communications traffic and binding.
3.1. MultiHop Radio DIP Switches
MultiHop ISM radio devices are defined with R2, R4, and R5 in the model number.
•
DXMxxx-xxR2 - MultiHop 900 MHz
•
DXMxxx-xxR4 - MultiHop 2.4 GHz
•
DXMxxx-xxR5 - MultiHop 900 MHz, 100 mW
•
DXMxxx-xxR9 - MultiHop 900 MHz, (Australia)
Making changes to the baud or parity settings requires that you make the same settings to the Modbus Client Communications section within the
DXM Configuration Software (Settings > General.
Disabling the serial port disables the ISM radio in the DXM1200. Selecting Transparent mode causes radio communications to be slower and
denies access to device I/O register data.
Table 1:DIP switch settings (Sheet 1 of 2)
Device Settings
Serial line baud rate 19200 OR User defined receiver
slots
14
LED
DIP Switch
Bank 1
Figure 1: ISM radio board
D1 Switches
1
2
OFF*
OFF*
© Banner Engineering Corp. www.bannerengineering.com
Antenna
Button
DIP Switch
Bank 2
3
4
1
D2 Switches
2
3
4
Advertisement
Table of Contents
