Table of Contents
Advertisement
C
M
B
ELLULAR
ODEM
OARDS
1.
SIM cards come in a credit card sized carrier. Carefully snap it out of the carrier.
2.
Make note of the IMEI number of the cellular modem and the ICCID number of the SIM card.
The numbers can be found on the cellular modem and the SIM card or SIM card carrier. You will need the SIM number to associate a
wireless plan to this SIM card.
3.
Insert the SIM card into the socket on the underside of the cellular modem while ensuring the conductive pads on the SIM card are
interfacing with the terminals of the modem.
There is a matching notch in the socket and SIM card that will only allow the SIM to be inserted with one orientation. Do not force the
SIM card into the socket.
4.
Orient the cellular modem according to the pin layout.
Modem
Antenna Cable
*SIM card is located on the underside of installed modem
Figure 3: DXM100, 150, and 1000
•
For the DXM100, DXM150, and DXM1000 models—Install the cellular modem board onto the processor board as shown. Use
the diagram to verify the orientation is correct.
•
For the DXM700 models—Install the cellular modem board onto the base board as shown. Use the diagram to verify the orienta-
tion is correct.
a.
Verify the pins are properly aligned.
b.
Verify the hole in the cell modem aligns with the hole on the DXM board.
c.
Firmly press the modem into the 24-pin socket.
5.
Attach the antenna cable between the cellular modem board to the base board as shown.
6.
Install the external cellular antenna on the DXM's SMA connector located next to the antenna cable.
5.3.1.2. Install the Cellular Modem (DXM1200 Models)
Follow these steps to install the cellular modem and antenna cable.
C
:
ONTEXT
ELECTROSTATIC DISCHARGE (ESD) SENSITIVE DEVICE
ESD can damage the device. Damage from inappropriate handling is not covered by warranty.
•
Use proper handling procedures to prevent ESD damage. Proper handling procedures include leaving de-
vices in their anti-static packaging until ready for use; wearing anti-static wrist straps; and assembling units
on a grounded, static-dissipative surface.
28
1
Figure 2: Installing the cellular modem
SIM card*
location
© Banner Engineering Corp. www.bannerengineering.com
2
Antenna Cable
*SIM card is located on the underside of installed modem
3
SIM card*
location
Modem
Figure 4: DXM700
Advertisement
Table of Contents
