Anatel; Warnings; Banner Engineering Corp Limited Warranty - Banner DXM1200-Bx Instruction Manual

Wireless controller
Hide thumbs Also See for DXM1200-Bx:
Table of Contents

Advertisement

11.10. ANATEL

Este equipamento não tem direito à proteção contra interferência prejudicial e não pode causar interferência em sistemas
devidamente autorizados. Para maiores informações, consulte o site da ANATEL

11.11. Warnings

DO NOT USE THIS DEVICE FOR PERSONNEL PROTECTION
Using this device for personnel protection could result in serious injury or death.
This device does not include the self-checking redundant circuitry necessary to allow its use in personnel
safety applications. A device failure or malfunction can cause either an energized (on) or de-energized (off)
output condition.
: Please download the complete DXM1200-Bx Wireless Controller technical documentation, available in multiple languages, from
IMPORTANT
www.bannerengineering.com for details on the proper use, applications, Warnings, and installation instructions of this device.
: Por favor descargue desde www.bannerengineering.com toda la documentación técnica de los DXM1200-Bx Wireless Controller,
IMPORTANT
disponibles en múltiples idiomas, para detalles del uso adecuado, aplicaciones, advertencias, y las instrucciones de instalación de estos dispos-
itivos.
: Veuillez télécharger la documentation technique complète des DXM1200-Bx Wireless Controller sur notre site www.bannerengi-
IMPORTANT
neering.com pour les détails sur leur utilisation correcte, les applications, les notes de sécurité et les instructions de montage.
Install and properly ground a qualified surge suppressor when installing a remote antenna system. Remote antenna configurations
installed without surge suppressors invalidate the manufacturer's warranty. Keep the ground wire as short as possible and make all ground
connections to a single-point ground system to ensure no ground loops are created. No surge suppressor can absorb all lightning strikes; do not
touch the Sure Cross® device or any equipment connected to the Sure Cross device during a thunderstorm.
Exporting Sure Cross® Radios. It is our intent to fully comply with all national and regional regulations regarding radio frequency emissions.
Customers who want to re-export this product to a country other than that to which it was sold must ensure the device is approved in
the destination country. The Sure Cross wireless products were certified for use in these countries using the antenna that ships with the
product. When using other antennas, verify you are not exceeding the transmit power levels allowed by local governing agencies. This device
has been designed to operate with the antennas listed on Banner Engineering's website and having a maximum gain of 9 dBm. Antennas not
included in this list or having a gain greater than 9 dBm are strictly prohibited for use with this device. The required antenna impedance is 50
ohms. To reduce potential radio interference to other users, the antenna type and its gain should be so chosen such that the equivalent isotrop-
ically radiated power (EIRP) is not more than that permitted for successful communication. Consult with Banner Engineering Corp. if the desti-
nation country is not on this list.
NEVER OPERATE A 1 WATT RADIO WITHOUT CONNECTING AN ANTENNA
Operating 1 Watt radios without an antenna connected will damage the radio circuitry.
To avoid damaging the radio circuitry, never apply power to a Sure Cross® Performance or Sure Cross
MultiHop (1 Watt) radio without an antenna connected.
ELECTROSTATIC DISCHARGE (ESD) SENSITIVE DEVICE
ESD can damage the device. Damage from inappropriate handling is not covered by warranty.
Use proper handling procedures to prevent ESD damage. Proper handling procedures include leaving de-
vices in their anti-static packaging until ready for use; wearing anti-static wrist straps; and assembling units
on a grounded, static-dissipative surface.

11.12. Banner Engineering Corp Limited Warranty

Banner Engineering Corp. warrants its products to be free from defects in material and workmanship for one year following the date of shipment.
Banner Engineering Corp. will repair or replace, free of charge, any product of its manufacture which, at the time it is returned to the factory, is
found to have been defective during the warranty period. This warranty does not cover damage or liability for misuse, abuse, or the improper
application or installation of the Banner product.
!
WARNING
© Banner Engineering Corp. www.bannerengineering.com
www.gov.br/anatel/pt-br/
P
S
M
RODUCT
UPPORT AND
AINTENANCE
61

Advertisement

Table of Contents
loading

Table of Contents