Table of Contents
Advertisement
®
Sure Cross
DXM1200-Bx Wireless Controller
3 ISM Radio Board (Slave ID 1)
The ISM embedded radio boards are available in either DX80 MultiHop or DX80 Performance.
D1
C
Figure 10. ISM radio board
Button Operation
For DXM models without a LCD display, use the button (B) to bind the ISM radio. For models with a LCD display,
use the ISM menu to bind the radio.
LED Operation
The LED located on the ISM radio module indicates power and communications traffic.
•
Solid green DX80 ISM radio LED indicates power.
•
Flashing green MultiHop ISM radio LED indicates operation.
•
Red and green combined: Communications traffic and binding.
ISM board LED operations also display on the LED on the right side of the I/O base board.
3.1 MultiHop Radio DIP Switches
The DX80 MultiHop architecture creates a tree network with a Master radio and one or more Repeater/Slave devices. The
MultiHop architecture is suited for networks requiring repeater devices to provide extended range or obstacle avoidance.
MultiHop ISM radio devices are defined with R2, R4, and R5 in the model number.
•
DXMxxx-xxR2 - MultiHop 900 MHz
•
DXMxxx-xxR4 - MultiHop 2.4 GHz
•
DXMxxx-xxR5 - MultiHop 900 MHz, 100 mW
•
DXMxxx-xxR9 - MultiHop 900 MHz, (Australia)
Making changes to the baud or parity settings requires that you make the same settings to the Modbus Master
Communications section within the DXM Configuration Software (Settings > General.
Important: Disabling the serial port disables the ISM radio in the DXM1200. Selecting Transparent mode
causes radio communications to be slower and denies access to device I/O register data.
Device Settings
Serial line baud rate 19200 OR User defined receiver
slots
Serial line baud rate 38400 OR 32 receiver slots
16
A
D2
B
1
OFF*
OFF
www.bannerengineering.com - Tel: + 1 888 373 6767
Plug the ISM radio into the I/O base board with the U.FL
antenna connector closest to the SMA connectors.
A - Antenna connector
B - Button
C - LED
D1 - DIP switches
D2 - DIP Switches
Typically, users will not need to adjust the DIP switch
settings on the physical radio modules. For the DXM1200
models, set the radio options using the LCD menu.
D1 Switches
2
3
4
OFF*
ON
D2 Switches
1
2
3
4
Advertisement
Table of Contents
