Table of Contents
Advertisement
2.
Remove the headlight unit bolt on each
side of the snowmobile and loosen the
quick fastener screws shown on the top
cover.
1. Headlight unit bolt
1. Quick fastener screw
3.
Disconnect the speedometer coupler and
headlight couplers, and then remove the
headlight unit.
4.
Loosen the locknut.
5.
Turn the adjusting bolt in or out until the
specified throttle cable free play is ob-
tained.
Periodic maintenance and adjustment
1. Locknut
2. Throttle cable free play adjusting bolt
3. Throttle cable free play
Throttle cable free play:
2.0–3.0 mm (0.08–0.12 in)
6.
Tighten the locknut.
7.
Connect the speedometer coupler and
headlight couplers, and then install the
headlight unit, making sure to insert the
projections on the headlight unit stay into
the slots on the bottom of the headlight
unit.
8.
Install the headlight unit bolts, and then
tighten them to the specified torque.
Headlight unit bolt tightening torque:
3 Nm (0.3 m·kgf, 2.2 ft·lbf)
9.
Tighten the quick fastener screws on the
top cover.
10. Install the shroud.
47
Advertisement
Table of Contents
