Table of Contents
Advertisement
1. Locknut
2. Control rod adjuster
3.
To increase weight transfer, turn the ad-
juster in direction (a), and to decrease
weight transfer, turn it in direction (b).
WARNING! Never adjust the control
rod beyond the range of the scale on
the special wrench, otherwise the con-
trol rod could be damaged, which
could lead to an accident or injury.
[EWS00181]
4.
Tighten the locknut while holding the ad-
juster in place. NOTICE: Make sure that
the special wrench is positioned at a
right angle to the control rod, and that
it is tightly fitted on the locknut or the
control rod adjuster.
Locknut tightening torque:
35 Nm (3.5 m·kgf, 25 ft·lbf)
RX10RTR / RX10MT
EWS00770
WARNING
The left and right adjusting nuts must be
set to the same position. Uneven settings
can cause poor handling and loss of sta-
bility.
1.
Loosen the locknut while holding the ad-
justing nut.
[ECS00322]
Control functions
1. Locknut
2. Control rod adjusting nut
2.
To increase weight transfer, turn the ad-
justing nut in direction (a), and to de-
crease weight transfer, turn it in direction
(b). WARNING! Never adjust the con-
trol rods beyond the maximum set-
ting, indicated by red paint; otherwise,
they could be damaged, which could
lead to an accident or injury.
[EWS00173]
27
Advertisement
Table of Contents
