Yamaha APEX RX10RY Owner's Manual page 32

Control functions
Rebound damping setting:
Minimum (soft):
11 click(s) in direction (b)*
Maximum (hard):
11 click(s) in direction (a)*
* With the adjustment dial in the stan-
dard position
RX10RTR
The compression damping force can be ad-
justed by turning the adjusting screw.
To increase the compression damping force,
turn the adjusting screw in direction (a). To
decrease the compression damping force,
turn the adjusting screw in direction (b).
NOTICE: Do not continue to turn the ad-
justing screw in direction (a) after it stops.
The shock absorber could be damaged
and damping force adjustments will not be
able to be made. Do not turn the adjusting
screw in direction (b) more than 20
click(s). Even if the adjusting screw is con-
tinually turned after 20 click(s), there will
be no change in the damping force. Be
sure to stop the adjusting screw at a posi-
tion where there is a click.
1. Compression damping force adjusting
screw
26
[ECS00301]
Compression damping setting:
Minimum (soft):
20 click(s) in direction (b)*
Standard:
11 click(s) in direction (b)*
Maximum (hard):
1 click(s) in direction (b)*
* With the adjusting screw fully turned in
direction (a)
ESU11044
Adjusting the control rods
The weight transfer can be adjusted by turn-
ing the adjuster on the control rod (RX10R /
RX10LT) or the adjusting nuts on the control
rods (RX10RTR / RX10MT).
RX10R / RX10LT
1. Check the control rod length using the
scale on the special wrench as shown.
1. Special wrench
2. Control rod length
3. Scale range
TIP
Use the special wrench in the owner's tool kit
to make this adjustment.
2. Loosen the locknut.
1
3
2