Hardware Reference Manual
GFK-3014F
2. Mount the M.2 M-Key board into the connector slot using standard
screws (Tx8 [0.45 Nm/5 in lb]) screw: ISO14583 M2.5 x 6 or M2.5 x 5.
Figure 4-24 M.2 M-Key Mounted to RXi2-EP IPC
4.6
Initial Startup
A few seconds after powering up, the RXi2-EP IPC system BIOS banner
displays on the screen. If you do not see any error messages up to this
point, the RXi2-EP IPC is running properly and ready to be configured for
your application.
4.7
UEFI Firmware Setup
To enter setup during the initial startup sequence: press the [Delete]
or [F2] key during the startup sequence. Adhere to the applicable on-
screen messages when prompted.
Note:
If the RXi2-EP IPC does not perform as described, some damage may have occurred during
shipment or the board is not installed or configured properly. Contact Emerson for technical
support. (Refer to the section
Hardware Interface
Contact
Information.)
Section 4
Feb 2023
31