Initial Startup; Uefi Firmware Setup; Rtc Battery Replacement; Figure 4-24 M.2 M-Key Mounted To Rxi2-Xp Ipc - Emerson RXi2-XP Hardware Reference Manual

Hardware Reference Manual
GFK-3022E
Figure 4-24
4.6

Initial Startup

A few seconds after powering up, the RXi2-XP IPC system BIOS banner displays on the screen. If
you do not see any error messages up to this point, the RXi2-XP IPC is running properly and ready
to be configured for your application.
4.7

UEFI Firmware Setup

To enter setup during the initial startup sequence: press the [Delete] or [F2] key during the startup
sequence.
Adhere to the applicable on-screen messages when prompted.
Note:
If the RXi2-XP IPC does not perform as described, some damage may have occurred during shipment or the
board is not installed or configured properly. Contact Emerson for technical support. (Refer to the section
Contact Information.)
4.8

RTC Battery Replacement

WARNING
There is danger of explosion if the battery is incorrectly replaced. Replace only with the same or equivalent type
to Murata CR2032W. Dispose used batteries according to Emerson provided instructions and applicable local
regulations.
CAUTION
Static-sensitive Devices: Handle only at static-safe work stations.
Installation and Startup
M.2 M-Key Mounted to RXi2-XP IPC
Installation and Startup
September 2021
28