Initial Startup - Emerson RXi2 Quick Start Manual

Initial Startup

For the first startup, it is advisable to connect a monitor,
keyboard, and mouse so that boot progress can be observed. For
headless operation after the first startup, a directly attached
monitor is not required.
Note: Please note that if RXi2- LP is being used without the
monitor (headless configuration), it will beep three times right
after power up. This is a normal condition, informing user that
Monitor is not present.
After making the connections, power on the IPC. A few seconds
after powering up, the RXi2-LP IPC system UEFI Firmware banner
and Emerson logo will display on the screen. If the user does not
see any error messages up to this point, the RXi2-LP IPC is
running properly and ready to be configured for an application.
For more information on UEFI Setup, please see the RXi2-LP
Hardware Reference Manual (GFK-3187).
If the RXi2-LP came with pre-installed software, the boot process
will continue to load the operating system and application
software.
8 RXi2 - LP Industrial PC Quick Start Guide GFK-3074F