Operating Instructions; Setting Water Temperature - Jacuzzi J-200 Owner's Manual

J-200
10.0

Operating Instructions

The spa control system has automatic functions that operate upon start
up and normal operation to protect the system. Upon the first power up,
the readout displays a sequence of information about the configuration of
the hot tub. Then the Priming Mode will begin, page 20.
Note: It is common for the heater to turn on after the spa is first filled
because tap water is often very cold. If water temperature, at this time,
is less than the factory default temperature setting of 100°F (38°C) the
heater will turn on and run until the water temperature rises to the factory
setting, then turn off.
10.1

Setting Water Temperature

The spa's thermostat provides optimum control of water
temperature. The temperature set point (set temperature) can be
adjusted from 65°F (18.5°C) to 104°F (40°C). To raise the set
temperature, press the WARMER (
temperature, press the COOLER (
WARMER ( ) or COOLER (
To access the overtemp feature that allows the spa to reach 106°F
(41°C) follow the steps below.
WARNING:
CAUSING SEVERE INJURY, BURNS, WELTS OR DEATH!
!
Water temperature in excess of 104°F (40°C) may injurious to
your health.
A. Raise the temperature to 104°F (40°C)
B. Press any temperature button, and while the Set
Temperature is displayed (flashing):
• Press and hold the MENU (
• Press the WARMER (
to raise the temperature to 105°F (40.5°C); press again to raise it
to 106°F (41°C).
Note: If the temperature is set to 105°F (40.5°C) and you would like to
raise the temperature to 106°F (41°C), you will have to repeat the steps
above.
C. When the overtemp feature has been activated, the icon after
the temperature will display an "o" as an indicator for being in the
overtemp mode.
D. If the Set Temperature is either 105°F (40.5°C) or 106°F (41.0°C)
and you simply press any temperature button while the Set Temperature
is flashing, the Set Temperature will jump to 104 °F (40.0°C).
Note: If the temperature is manually changed below 104°F (40°C) or
power is turned off and you would like to raise the temperature to 106°F
(41°C) again, you will have to repeat the steps above.
28
) button. To lower the set
) button. The first press of either
) button displays the set temperature.
RISK OF HYPERTHERMIA (OVER-HEATING)
) button then;
) button at the same time. Press once