Jacuzzi J-200 Owner's Manual page 25

Table of Contents

Advertisement

4. Activate Jets Pumps
Turn on jets pump(s) to ensure proper mixing when
adding start-up chemicals in step 5.
5. Add Start-Up Chemicals
Add the spa water chemicals as recommended by your authorized
Jacuzzi dealer. See Section 13.0 "Water Quality Maintenance" (page
45) for general guidance.
WARNING:
Never leave chemicals opened and accessible to anyone.
!
Use chemicals according to the vendors instructions. Always
store chemicals in a safe and/or locked location. Keep away
from and out of reach of children.
6. Establish A Stable Sanitizer Reading
Establish a stable sanitizer reading of no less than 1.0 ppm free
chlorine or 2.0 ppm bromine. To ensure healthy water conditions,
always maintain a constant sanitizer reading within the levels
recommended on the inside cover of this manual.
7. Set Spa To Heat
To warm spa water to a comfortable temperature, follow
these steps:
The LCD display on the control panel displays the actual
temperature of the spa water. Press either the COOLER (
WARMER (
you want the water to heat to a different temperature, simply press
COOLER (
temperature increases or decreases by 1°F (0.5°C) each time one of
these buttons is pressed.
The heater will turn off when the temperature corresponding to the
thermostat setting is achieved.
Important Heater Details:
The maximum water temperature setting for your spa is 104°F
(40°C) and the minimum setting is 65°F (18.5°C).
• For North America spas connected to a 40-amp service, jets pump
#1 must be set to low speed and jets pump #2 must be turned off to
operate the heater.
• Setting the thermostat at maximum will not accelerate the heating
process. This will only result in a higher ultimate temperature.
• The heater operates until the water reaches 1°F (0.5°C) above
the programmed "set temperature," then turns off. The heater will
reactivate after the water cools to approximately 1°F (0.5°C) below
the "set temperature."
RISK OF POISONING OR DEATH.
) button once to display the "set" temperature. If
) or WARMER (
) within 5 seconds. The set
J-200
1
2
) or
21

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

J-285J-275J-245J-235J-225J-215

Table of Contents