Autofill - AGFA Classic E.O.S. Reference Manual

Autofill

The Autofill function is only applicable when using the 5270/105 processor in com-
bination with the LR 3300 S Laser Imager.
The Autofill function allows for the automatic filling of developer and fixer tanks,
when the level of the developer or fixer in the processor tank is too low.
The following message indicates that the level of the developer in the processor
tank is too low:
'HYHORSHU
OHYHO ORZ
Setting the automatic filling setting ON or OFF:
1
Press any key for more than 3 seconds to start.
You can press the Escape key at any time to quit a menu without making changes.
2
Press the Down key twice followed by the Confirm key to select 'Auto filling'.
$XWR ILOOLQJ
6HUYLFH
3
Press the Up and Down keys to select the required Auto filling setting (ON or OFF).
$XWR ILOOLQJ
2))
4
Press the Confirm key to activate the selected setting.
If the 'Auto filling' function is activated, the tanks (Developer, Fixer 1 & 2) will be
filled automatically. Afterwards, the temperature of the tanks will be adjusted to
the set developer or fixer temperature.
36.
50
or, for the fixer,
√
Æ
Ç
ÆÇ
)L[HU
OHYHO ORZ
Refer to 'Developer temperature' on page
√
1280C GB 20001204