Fixer replenishment rate
The default setting is 400 ml/m².
You can try to increase the rate if fog-level, speed and contrast of the film is
affected. Keep in mind that changing the fixer replenishment rates can result in
bad archival quality.
The fixer replenishment rate is not adjustable during film processing.
Setting the fixer replenishment rate
1
Press any key to start.
You can press the Escape key at any time to quit a menu without making changes.
2
Press the Confirm key to select 'Settings'.
6HWWLQJV
/DQJXDJH
3
Press the Down key three times followed by the Confirm key to select 'Replen-
ishment'.
'U\HU
5HSOHQLVKPHQW
4
Press the Down key two times followed by the Confirm key to select 'Rates'.
5DWHV
1280C GB 20001204
Æ
Ç
Æ
Ç
43