Table of Contents
Advertisement
and no fallback
N1 *
When originating or answering, start
handshaking only at the communication
standard specified by S37 register and
"ATBn". During handshake, fallback to a
lower speed may occur
On
Go on-line
O0
Return modem to a previously
established state (return to data mode)
O1
Begin a retrain sequence, then return to
on-line state
O3
Issue a rate re-negotiation, then return to
on-line state
P
Enable pulse dialing
Qn
Result code display options
Q0 *
Result code enabled
Q1
Result code disabled
T
Enable tone dialing
Vn
Result code form
V0
Display result code in numeric form (see
also the "Result Code Options Table)
V1 *
Display result code in verbose (text) form
Wn
Select extended result code options
W0
CONNECT result code reports DTE
speed. Disable protocol result codes. (see
also the "Result Code Options Table")
W1
CONNECT result code reports DTE
speed. Enable protocol result codes
W2 *
CONNECT result code reports DCE
speed. Enable protocol result Codes
Xn
Select result codes/call progress options
X0
Display CONNECT or "1" for all speeds.
Ignore dial tone and busy tone detection
X1
Display connect message and the
modem's data rate, and an indication of
the modem's error correction and data
PLANET ENW-3503 User's Manual
Appendix C
8-3
Advertisement
Table of Contents
