Table of Contents
Advertisement
&C1 *
DCD turns on when the remote modem's
carrier signal is detected, and off when
the carrier signal is not detected
&Dn
Data Terminal Ready (DTR) option
&D0
DTR ignored
&D1
Go to command mode on on-to-off DTR
transition
&D2 *
Hang up and go to command mode on
on-to-off DTR transition. Auto-answer is
disabled if DTR is low.
&D3
Hang up and reset from user profile 0 on
the on-to-off DTR transition
&F
Recall factory default setting as active
configuration
&Gn
V.22bis guard tone option
&G0 *
No guard tone
&G1
550 Hz guard tone
&G2
1800 Hz guard tone
&Kn
Set local flow control
&K0
Disable flow control
&K3 *
Enable bi-directional hardware flow
control (CTS/RTS)
&K4
Enable bi-directional software flow control
(XON/XOFF)
&Pn
Pulse dialing make/break ratio selection
&P0
Make=39%, Break=61%, international
version (Default) Make=33%, Break=67%
for use in 20pps, Japanese version
&P1
Make=33%, Break=67%, international
version. Make=33%, Break=67% for use
in 10 pps, Japanese version (Default)
&Qn
Async communications mode options
&Q0
Async mode, buffered (same as "AT\N0")
&Q5 *
Error control mode, buffered (same as
"AT\N3")
PLANET ENW-3503 User's Manual
Appendix C
8-5
Advertisement
Table of Contents
