Panasonic KX-TG4000B Operating Instructions Manual page 96

Before Requesting Help
Problem
While programming or
searching, the unit starts to
ring and stops the
program/search.
The caller's information is
not displayed.
The display goes to the
standby mode while
viewing the Caller List or
directory.
When a second call is
received on the same line,
the unit does not display
the new caller's
information.
You cannot redial the last
number dialed.
You cannot have a
conversation using the
headset.
The BATTERY indicator
light does not go out after
the battery has been
charged.
96
• To answer the call, lift the handset, press
(DIGITAL!SP-PHONE)
whose indicator is flashing quickly. Start
again from the beginning after hanging up.
• The base unit is removed from the ring
group. Add to the ring group (p. 23).
• Other telephone equipment may be
interfering with your phone. Disconnect it
and try again.
• Other electrical appliances connected to
the same outlet may be interfering with the
Caller ID information.
• Telephone line noise may be affecting the
Caller ID information.
• Do not pause for over 60 seconds while
searching.
• If another call is received on the same line
while;
– the Automated Attendant System or
Answering System is responding to a call,
or
– a call is placed on hold,
the caller information will not be displayed.
• The line mode selection is incorrect. See
page 55.
• If the last number dialed was more than 32
digits long, the number will not be redialed.
• Access numbers entered after pressing
will not be included when redialing.
(TONE)
• Make sure that the headset is plugged into
the headset jack properly (p. 86).
• If "ENTER=Headset" is displayed, press
to switch from the speakerphone
(ENTER)
to the headset.
• This is normal.
Remedy
or the line button