Setting The Unit To Call A Pager - Panasonic KX-TG4000B Operating Instructions Manual

Pager Call
To erase the pager number
1. Press
(FUNCTION)
or until the arrow points to
"Pager setting", and press
H.
2. While "Pager number" is at the
arrow, press H.
3. Press
(CLEAR)
4. Press
(ENTER)
•The pager call mode will automatically
return to OFF (see below).

Setting the Unit to Call a Pager

1
Press
(FUNCTION)
2
Press
points to "Pager setting",
and press H.
3
Press
points to "Pager on/off", and
press H.
• "Off" (factory preset) is displayed.
4
Select "On" by pressing
.
P a g e r o n / o f f
∨ ∧
5
Press
(ENTER)
• A beep sounds.
• To return to the standby mode,
press (EXIT).
• If using the base unit, "Pager" will
be displayed.
To turn off the pager call mode,
select "Off" in step 4.
84
, and press
.
.
.
or until the arrow
or until the arrow
: O n
E N T E R = S a v e
.
To erase the pager display
number
1. Press
or
"Pager setting", and press
H.
2. Press
points to "Pager display #",
and press H.
3. Press
4. Press
If you have not subscribed to a Caller
ID service, the caller's telephone
number will not be displayed on your
pager.
• If another message is received before
the unit alerts your pager for a
previous message, the previous caller
information will not be sent to your
pager. Only the last call received will
be sent to your pager.
or
• If someone else makes or answers
another call with your unit before the
unit alerts your pager for a previous
message, the unit will stop alerting
your pager for that message.
• If you receive a telephone number on
your pager but cannot recognize the
caller, you may have received a direct
inward dial (DID) call, such as from a
PBX. Please call your unit to check
the caller's message.
, and press
(FUNCTION)
until the arrow points to
or until the arrow
.
(CLEAR)
.
(ENTER)