Table of Contents
Advertisement
About your projector
Remote control
Front
1
2
3
4
5
6
7
8
9
10
1
Remote control indicator
Blinks if any button in the remote control is pressed.
2
Power on <b> button
Sets the projector to projection mode when the <主电源> switch
on the projector is set to <开> and the power is turned off
(standby mode).
3
Power standby <v> button
Sets the projector to the state where the projector is turned off
(standby mode) when the <主电源> switch on the projector is
set to <开> and in projection mode.
4
<菜单> button/<执行> button/asqw buttons
Used to navigate through the menu screen. (x page 96)
5
<屏幕显示> button
Switches the on-screen display function on (display) or off
(hide). (x page 91)
6
<自动设置> button
Automatically adjusts the image display position and signal level
while projecting the image.
[PROGRESS] is displayed while in automatic adjustment.
(x page 92)
7
<宽高比> button
Switches the aspect ratio of the image. (x page 92)
8
Number (<0> - <9>) buttons
Used for entering an ID number or a password in a multiple
projector environment.
9
<状态> button
Displays the projector information.
10 <灯> button
Pressing this button lights up the remote control buttons. The
lights will go off when the remote control operation goes idle for
10 seconds.
11 <INPUT MENU> button
Displays the input selection screen. (x page 79)
Chapter 1 Preparation — About your projector
Top
11
12
13
14
Bottom
15
16
17
18
19
20
21
A strap can be attached
depending on the usage.
22
23
12 Input selection buttons (<HDMI>, <DISPLAYPORT>,
<DVI-D>, <SDI>, <DIGITAL LINK>, <SLOT 1>, <SLOT 2>)
Switches the input signal to project. (x page 77)
<DISPLAYPORT> button, <DVI-D> button, <SDI> button,
<SLOT 1> button, and <SLOT 2> button can be used when the
optional Interface Board equipped with corresponding input is
installed in the slot on the projector.
Following buttons are not used with this projector.
<RGB1> button, <RGB2> button, <VIDEO> button, <S-VIDEO
Y/C> button
13 <快门> button
Used to temporarily turn off the image. (x page 91)
14 <测试模式> button
Displays the test pattern. (x page 93)
15 Lens buttons (<聚焦>, <变焦>, <移位>)
Adjusts the focus, zoom, and lens shift. (x page 79)
16 <功能> button
Assigns a frequently used operation as a shortcut button.
(x page 92)
When the <功能> button is held down, the [FUNCTION
BUTTON] screen is displayed. (x page 193)
17 <默认> button
Resets the setting of the displayed sub-menu to the factory
default. (x page 97)
18 <ID 设定> button
Sets the ID number of the remote control in a multiple projector
environment. (x page 33)
19 <ID 全部> button
Used to simultaneously control all the projectors with a
single remote control in a multiple projector environment.
(x page 33)
20 <锁定> button
Used to prevent unintended operation by careless pressing of
the buttons and prevent draining the remote control batteries.
Operation of each button on the remote control is disabled by
sliding the <锁定> button toward the arrow.
21 Remote control signal transmitter
ENGLISH - 25
Advertisement
Table of Contents
