Table of Contents
Advertisement
Adjusting the waveform
Project the luminance adjustment signal of a commercial test disk (0 % (0 IRE or 7.5 IRE) – 100 % (100 IRE)) and
adjust.
1)
Select "Select line (luminance)" on the waveform monitor.
2)
Adjust black level.
f Adjust the black level 0 % of the video signal to the 0 % position of the waveform monitor using the
[PICTURE] menu → [BRIGHTNESS].
3)
Adjust white level.
f Adjust the white level 100 % of the video signal to the 100 % position of the waveform monitor using the
[PICTURE] menu → [CONTRAST].
Adjusting red, green, and blue
1)
Set [COLOR TEMPERATURE] to [USER1] or [USER2] (x page 102).
2)
Select "Select line (red)" on the waveform monitor.
3)
Adjust dark red areas.
f Use [RED] in [WHITE BALANCE LOW] to adjust the black level 0 % of the video signal to the 0 % position
of the waveform monitor.
4)
Adjust bright red areas.
f Use [RED] in [WHITE BALANCE HIGH] to adjust the white level 100 % of the video signal to the 100 %
position of the waveform monitor.
5)
Use the procedure for [RED] to adjust [GREEN] and [BLUE].
Note
f Confirm that the [SIGNAL LEVEL] setting of the input signal is correct before adjusting the black level.
Check the [SIGNAL LEVEL] setting in following menu in accordance with the input.
g The [DISPLAY OPTION] menu → [DIGITAL LINK 输入] → [SIGNAL LEVEL]
g [SIGNAL LEVEL] under the [DISPLAY OPTION] menu → [SLOT 输入] → [SINGLE LINK SETTING]/[DUAL LINK SETTING]/[QUAD LINK
SETTING]
[CUT OFF]
Each red, green, and blue color component can be removed.
1)
Press as to select [CUT OFF].
2)
Press the <执行> button.
f The [CUT OFF] screen is displayed.
3)
Press as to select [RED], [GREEN], or [BLUE].
4)
Press qw to switch the item.
[OFF]
[ON]
160 - ENGLISH
Chapter 4 Settings — [DISPLAY OPTION] menu
Image position
Disables cutoff.
Enables cutoff.
Image displayable area
Advertisement
Table of Contents
