Igniter As - Asko TLS752 Manual

1. Function
• Igniter for fuel gas ignition.
• Igniter heats up quickly when power is supplied. If fuel gas is
injected to the surrounding area of igniter, gas is ignited by
the heat of igniter.
2. Specification
• A heating element made by Silicon Carbide
• Electric rating : 120V 4.0A (steady-state current)
• Temperature rating : reaches 1800°within 30 seconds
• Type name : DC033
3. Checking method of mal-function
• Igniter is heated up to very high temperature. Therefore, extreme caution is required in handling to prevent
burn.
• At room temperature, resistance between two terminals of this part is generally between 300~400Ω
• Part is defective if resistance between terminals measured after separating cable connected to igniter is 250Ω
or less.
• Part is defective if cracks are found when separating igniter and closely observing the surface.
• In two of the above conditions, igniter is defective, therefore needs to be replaced.
4. Procedure of replacement
① Plate Top Remove
② Panel F Ass'y Remove
③ Cabinet Front Ass'y Remove
④ Frame Upper Remove
⑤ Drum Ass'y Remove
⑥ Cover Fan Remove
⑦ Separate the connected cable and unfasten 1 screw
to separate parts.
⑧ Assemble part in reverse order of the above
procedures.

Igniter As

60
Part Code : 36189L5800
Laniter As
Laniter As