Asko TLS752 Manual page 31

8) Less Time
A. Pressing this button decreases time by a minute.
B. The time decreases up to 00:15 (minutes)
C. You can change time in Manual Dry Course and Time Selection. Also Anti-crease can be selected/cancelled.
9) Delay Start
A. Preset time indicates starting time of the cycle.
B. When pressing Delay Start button, time changes in the order of 1 → 2 → 3 → 4 → ... → 12 → 1.
C. After selecting preset time, cycle change is possible before entering preset mode by pressing Start/Stop
button. However, cycle cannot be changed after entering preset mode.
D. To preset operation, select cycle → select preset time → press Start/ Stop button.
E. The selected cycle is displayed for 3 seconds when pressing Start/Stop button after entering preset mode to
check the selected cycle.
10) Rack Dry
A. If you press Rack Dry button, time is set to 55 minutes without default temperature.
B. Only Low or Ultra Low is selected with the operation of Heater 1.
C. You can adjust time with More/Less button.
D. Once Rack Dry is chosen, you can not select Anti-crease, Damp Signal.
11) Anti-crease
A. Selecting Anti-crease does not change course time.
B. In order to prevent wrinkle, the motor continues to run for 10 seconds and stops for 5 minutes and 50 seconds
while the heater is off after all the operation (including cooling) finishes.
C. The course stops only you press Start/Stop or Power button.
D. You can select/cancel this course during operation or pause.
12) Anti Static
A. The Anti Static injects steam late in the drying cycle to reduce the static electricity caused by dry fabrics
rubbing together.
B. The Anti-Static the case that setting became drying was over to an alternative possibility course, and a Steam
+ cooling function is progressed. (A selectable course : Evertyday/Normal, Towel, Bulky)
13) Damp Signal
A. This button works only in Sensor Dry Course without changing time.
B. The unit beeps every 3 seconds after the target humidity is achieved until the operation is finished.
C. The beep stops if the door is opened or operation stops. When the operation is resumed, the beeper is off.
31