Dryer Service Notices - Asko TLS752 Manual

❏ Dryer Service Notices
No. Service
1 Replacing the
humidity sensor
2 Replacing/fixing panel f assy PCB/BUTTON/HARNESS
Replacing the lifter
3
Replacing roller assy
4
5 Replacing the terminal block TERMINAL BLOCK
6 Replacing the heater
Replacing the burner
7 Replacing the sensor
8 Door assembly
9 Disassembly/assembly of
the door as
10 Disassembly/assembly of
the motor as
Replacing the belt
11 Disassembling the drum
Parts
Humidity sensor
LIFTER
ROLLER
Drying heater
GAS BUNNER
Temp and safety sensor
Door hinge
Door as
MOTOR AS BELT
DRUM roller of sup r sup f.
before fastening.
47
Notices
Be careful of the terminal connection
Be careful of loose attachment
Be sure that the panel f assy does not
interfere in the drum after the service
Remove only the plate top to replace the part
Be cautious of the direction of the roller/
insertion of the washer
Be careful of wiring connection
Do not use oversized screws.
Be sure of the proper assembly. (Loosening
should be little)
Be careful that no object (e.g. screws) is
dropped into the heater when assembling.
Be careful of the direction / insertion of the
connector. Use only standard screws.
Be careful of the direction / insertion of the
connector. Use only standard screws.
Be careful not to scratch chromium plating
when fastening the screws to fix the door as.
A claim is expected.
Be careful about the up/downward direction of
door glass and insertion of a gasket. Use only
standard screws.
Be careful not to nip the finger when
assembling the motor (hold the edge of the
motor).
Be careful about the direction of the belt and
insertion of a fan/case fan (incorrect assembly
may cause noise) as well as the connector.
Do not drop the motor. Be sure that he drum
is accurately put into the