Table of Contents
Advertisement
de
Program overview
0
settings
Program entry
position
After you have set a program, you will be shown the preset program settings. These
are recommendations for the set program and vary. You can adjust the program
settings to achieve an optimal washing process for your laundry.
You can find an overview of the possible program settings
at How you can adjust program settings at
vario speed
Anti-crease
prewash
stains ã:
Ì / ë / â / ì
Temp. ° C
sling
Completed in
32
function
Wash / dry in less time with results comparable to the set program
without the vario Speed setting.
Note:
The energy consumption when washing and the water consumption when drying
is higher than when the program is running without the vario Speed setting.
Crease reduction through a special spin process with reduced spin
speed and subsequent loosening.
Note:
After the wash cycle, the laundry is more humid than with programs without the
anti-crease setting.
Additional prewash for washing heavily soiled laundry.
Note:
Divide the detergent required for the pre-wash and main wash into the compartment
I. and II on.
Put the laundry items together as usual. Choose a program.
Select a type of stain (depending on the selected program). Start the program.
Olie / blood / red wine / grass
The device adjusts the average washing temperature, the drum movements
and the soaking time to the type of stain in question. With hot or cold water,
gentle or intensive washing and long or short soaking, an optimal washing
program for the respective type of stain is put together. In this way, stains
are optimally treated.
Adjusting the temperature.
Note:
The temperature that can be set depends on the program.
Adjusting the spin speed (in rpm (revolutions per minute).
Note:
The spin speed that can be set depends on the program.
setting 2:
The laundry is not spun at the end of the wash cycle and remains wet in the
drum. The water is only pumped out.
Before the program starts you can delay the end of the program in up to a maximum of 24
hours using the, Finished buttons.
The set number of hours, e.g. 8h, is shown in the display and counted down until the
program begins. After the program has started, the program duration is displayed.
Advertisement
Table of Contents
