12th
Insert the service flap and snap in
th.
Device help
Disruptions
Device does not start
Program does not start
Wrinkling
Detergent / fabric softener
drips from the cuff and remove the mark Max in the detergent drawer.
collects on the door or in
the cuff
Detergent residue on the
Laundry
Cause / remedy
Check the power plug and the fuses. Make
sure, that
the door is closed w ( Child
■
lock) is deactivated, you
■
pressed Start reload
■
Note:
Is a program delay through Completed in set, the
program starts at a later time.
If the display shows for 5 seconds à • ‹ shows after you have
switched the device on or off, the device is in shop mode.
Switch off shop mode as follows:
1.
Switch the device off and on again.
2.
Wait for the message à • ‹ has gone out in the display.
3.
Press and hold Start Reload for at least 5 seconds. Appears in
the display ‹" " and the device switches off automatically. Shop
mode is now deactivated and you can use the device as usual.
Load or spin speed too high.
■
Wrong program set for the type of fabric. You will find all the
■
necessary information in the program table.
Take the laundry out of the drum as soon as it is dry.
■
Lying in the drum causes creases.
Too much detergent / fabric softener in the detergent drawer. Beach
Occasionally, phosphate-free detergents contain water-insoluble
■
residues.
Rinse spin start
■
Brush out laundry after washing
■
Clean and maintain
13.
Close the service flap.
de
49