Advertisement
Device management
In the menu Device management, the name can be changed,
deleted, etc.
Use + to search for other RAMSES top3 devices.
Info
In the Info menu you will find all the information about your
RAMSES top3 device (device type, serial number, etc.).
10. Encode RAMSES 813 top3 HF with a
new receiver
If you want to connect (encode) a new receiver (REC 1, REC
11) with RAMSES 813 top3 HF – in case the existing device is
defective – you should observe the following:
First make the settings at the clock
thermostat before you encode it with
the receiver.
Edit name
Delete
Search for new devices ...
Device list
Connect the clock thermostat to the receiver
Press > 2 x and go to Settings using >. The symbol
†
flashes.
Confirm with +.
†
Use + or – to select wireless
†
Confirm with >.
†
The wireless symbol
flashes and the channel is connected
to the receiver.
L Before you carry out the coding, the receivers must be
mounted, connected and the antenna aligned (see below).
Range test for clock thermostat
You can test the range of the HF transmitter by having the
device transmit continuously.
Use + or – to select wireless
†
Confirm with +. Off and 1 appear.
†
Select 2 (for range test) using >.
†
Confirm with +. The process starts. During transmission, 4
†
dashes are displayed in succession.
Now the clock thermostat sends a signal every 3 s for 15 min.
The control indicator on the receiver and the
status indicator of the channel light up in this cycle. During
the test phase, the location of the thermostat and the recep-
tion quality can be optimised. The relays are not switched.
Place the clock thermostat in the desired living area.
†
You have optimal reception when all LEDs light up during
transmission. At least one green LED should light up.
Finish the range test
Press + or – to stop sending. Off appears again in the
†
display.
Using > takes you back to the wireless menu
†
Encode the clock thermostat with the receiver
After you have aligned the antenna of the receiver, you can
re-teach the connection to the receivers. During the teach-in
procedure, 4 dashes appear in the display in succession.
Use + or – to select wireless
†
Confirm with +. Off and 1 appear.
†
Confirm with +. The process starts. During transmission, 4
†
dashes are displayed in succession.
Align the antenna of the receiver
L Do not place antenna next to water pipes or electricity
cables.
Connect the receiver to the operating voltage.
†
Align the antenna vertically.
†
In the event of errors (several LEDs light up), align antenna
†
so that as few LEDs as possible light up.
Encode channel C1 (e. g. room 1)
L Delete the old code before you recode the device!
.
→
.
→
.
.
→
11
Advertisement
