Daikin Clima-Flex CLIV Series Installation, Operation And Maintenance Manual page 42

!
WARNING
Risk of electric shock, can cause injury and death.
Disconnect all power sources before inspecting the fan.
Disconnect all electrical power sources when working inside
the unit. Potentially lethal voltages exist within the equipment
during operation.
Review all cautions and WARNINGs contained in this
manual. Only qualified personnel should service this unit.
CONDENSER
Maintenance consists mainly of removing dirt and debris from
the outer surface of the fins and repairing any damage to them.
For units installed in corrosive environments, cleaning of the fins
should be part of the regular maintenance program.
In this type of installation, dust and debris should be removed
promptly to avoid build-up that will interfere with the regular
operation of the unit.
!
WARNING
Risk of electric shock, may cause injury and death.
Risk of serious injury. Fan may start up and cause injury.
Disconnect all power sources before inspecting the fan.
Cleaning of the hydronic circuit filter,
if present.
Visual inspection of all water pipes
for leaks.
Replacing the water in the hydronic
circuit.
iom-cliv-cf-eng
!
!
HYDRAULIC MAINTENANCE
Jan Feb Mar Apr
Plan x x x
Real
Plan x x x
Real
Plan x x x
Real
42
FILTER DRIER
Any particles from the condenser piping, compressor or various
components are swept by the refrigerant into the liquid line and
trapped by the filter drier.
It is recommended that the filter drier be replaced each time a
refrigerant line repair is performed.
EXPANSION VALVE
The function of the expansion valve is to maintain adequate
supply of refrigerant to the evaporator. This is in order to satisfy
the charge conditions.
Before adjusting the superheat, verify that the unit charge is
correct and that the liquid line is completely full and free of bubbles,
and that the circuit is operating under stable load conditions The
superheat suction for the evaporator suction discharge is factory
set for 10°F.
!
WARNING
Risk of explosive discharge of refrigerant at high pressure.
This can cause personal injury or equipment damage.
Never loosen refrigerant or electrical line connections until
the compressor has been depressurized on both sides.
ANNUAL MAINTENANCE SCHEDULE
Before performing any work on the unit, make sure you have
the proper Personal Safety Equipment (EPS), and that the unit
is turned off and idle. It is also recommended that the unit be
turned on 24 hours prior to first start-up to begin warming up the
compressor crankcase.
May Jun Jul Aug
x x x x x
x x x x x
x x x x x
Unit Maintenance
!
Sep Oct Nov Dec
x x x x
x x x x
x x x x
www.clima-flex.com