Setup And Procedures Before Operation; Handling Precautions - Mitsubishi MELSEC-Q Q62DAN User Manual

4 SETUP AND PROCEDURES BEFORE OPERATION

4 SETUP AND PROCEDURES BEFORE OPERATION

4.1 Handling Precautions

4
4 - 1
(1) Do not drop the module case or subject it to heavy impact.
(2) Do not remove the PCB of the module from its case. Doing so may cause the
module to fail.
(3) Be careful not to let foreign particles such as swarf or wire chips enter the module.
They may cause a fire, mechanical failure or malfunction.
(4) The top surface of the module is covered with a protective film to prevent foreign
objects such as wire burrs from entering the module during wiring. Do not remove
this film until the wiring is complete. Before operating the system, be sure to
remove the film to provide adequate heat ventilation.
(5) Tighten the screws such as module fixing screws within the following ranges.
Loose screws may cause short circuits, failures, or malfunctions.
Screw location
Module fixing screw (M3 screw)
Terminal block screw (M3 screw)
Terminal block mounting screw (M3.5 screw)
FG terminals screw (M3 screw)
1: The module can be easily fixed onto the base unit using the hook at the top of
the module.
However, it is recommended to secure the module with the module fixing
screw if the module is subject to significant vibration.
2: Q68DAVN, Q68DAIN, Q68DAV, Q68DAI only.
(6) To mount the module on the base unit, fully insert the module fixing latch into the
fixing hole in the base unit and press the module using the hole as a fulcrum.
Improper installation may result in a module malfunction, or may cause the
module to fall off.
Tightening torque range
1
0.36 to 0.48 N . m
0.42 to 0.58 N . m
0.66 to 0.89 N . m
2
0.42 to 0.58 N . m
MELSEC-Q
4 - 1