Using An External Component Via Ads Adapter - Oem Features - Kenwood DMX809S Quick Start Manual

Other External Components Other External Components
Connecting a camera to the AV-IN
terminals
See page 58.
• When connecting the external camera to the AV-IN
terminals, select [Camera] for the <AV Input>
setting (page 49).
For the rear view camera: The rear view screen
is displayed by shifting the gear to the reverse (R)
position when <Rear Camera Interruption> is set to
[ON] (page 49).
• A caution message appears on the screen. To
remove the caution message, touch the screen.
For the front view camera: The front view screen is
displayed by releasing the gear from the reverse (R)
position when <Front Camera Interruption> is set to
other than [OFF] (page 49).
Watching camera view
1
Display the camera view.
From the Home screen (page 3), touch as
follows:
The camera view screen of one of the connected
camera is displayed.
36 ENGLISH
2
Change the camera view.
Touch the upper portion of the screen shown
below.
• Each time you touch, camera view changes
among front view camera, rear view camera, and
AV-IN camera.
To display parking guide line
(Only for the rear view camera)
Touch the area shown below, or set <Parking
Guidelines> to [ON] (page 49).
• To close the parking guidelines, touch the same area
again.
To exit the camera screen
Press the HOME button on the monitor panel or touch
the area shown below.
• When the gear is released from the reverse (R)
position, the screen also returns to the previous
playback source screen.
Using an external component via ADS
adapter — OEM Features
By connecting this unit to the bus system of the
vehicle using iDatalink (commercially available), this
unit can access the satellite radio source provided for
the vehicle and vehicle information can be displayed
on this unit.
• Displayable screens, key names, and screen names
vary depending on the type of the connected
iDatalink and the model of the vehicle.
• For details, visit <www.idatalink.com/>.
Connecting an ADS adapter
See page 58.
Using an external component via an ADS
adapter
• For settings to use an ADS adapter, see page .51
1
Select "OEM Features" as the source.
From the Home screen (page 3), touch as
follows: