Audio Settings - Kenwood DMX809S Quick Start Manual

Audio Settings

Audio Settings
1
Display the <Audio> screen.
On the source/option selection screen (page 11):
Then, on the <Setup> screen, touch as follows:
[Audio] (1) → [Enter] for the item you adjust (2).
Setup
Equalizer
Audio Enter
Display Sound Effect
Enter
Fader / Balance
Input Enter
Speaker / X'over
System Enter
Time Alignment Enter
2
Adjust the item.
The <Audio> settings are not adjustable;
• When the unit is in standby (STANDBY).
• When the Bluetooth phone is used (making or
receiving a call, during a call, or while voice dialling).
• When Apple CarPlay or Android Auto is used for
phone calling.
ENGLISH
26
<Equalizer>
The following adjustments are memorized for each
source until you adjust the sound again.
Selecting a preset sound mode
Select a preset sound mode on the <Equalizer>
screen (1).
• Pops/Easy/Top40/Jazz/Powerful/Rock/Flat
(Initial)/Bass Boost/User1/User2/User3/User4
Equalizer
SRC Name
Preset
Flat
[dB]
+9
+7
+5
+3
0
-3
-5
-7
-9
62.5 100 160 250 400 630 1k 1.6k 2.5k 4k 6.3k 10k
Bass EXT ON OFF EQ INIT
SW Level 0
ALL SRC
<SW Level>
Adjusts the subwoofer level (2).
• Not adjustable when <None> is selected for
subwoofer on the <Speaker Select> screen.
• –50 to +10 (Initial: 0)
To apply the adjusted equalizer to all playback
sources, touch [ALL SRC], and then touch [OK] to
confirm.
<Sound Effect>
Adjust the sound effect.
<Loudness>
Adjusts loudness.
• OFF (Initial)/Low/High
<Bass Boost>
Selects the bass boost level.
• OFF (Initial)/Level 1/Level 2/Level 3
<Drive Equalizer>
Reduces the driving noise by raising the bandwidth.
• OFF (Initial)/ON
<Space Enhancer>
Virtually enhances the sound space using the Digital
16k [Hz]
Signal Processor (DSP) system (except for Digital Radio
and Radio).
Select the enhance level.
• OFF (Initial)/Small/Medium/Large
<Supreme>
Compensates the sound lost while audio compression
process (except for analog signals).
• OFF/ON (Initial)
<Realizer>
Virtually makes the sound more realistic using the
Digital Signal Processor (DSP) system. Select the sound
level.
• OFF (Initial)/Level 1/Level 2/Level 3
<Stage EQ>
Moves the center of the sound to the lower or higher
point. Select the height.
• OFF (Initial)/Low/Middle/High