Table of Contents
Advertisement
Figure 139. Installing the system board
Next steps
1. Replace the following components:
a.
Trusted Platform Module (TPM)
NOTE:
The TPM Module must be replaced only while installing new system board.
b.
Internal USB card (if removed)
c.
OCP card (if removed)
d.
LOM card (if removed)
e.
Processor and heat sink module
f.
Memory modules
g.
Expansion card risers
h.
Rear drive module
i.
VGA port (if removed)
j.
Serial COM port (if removed)
k.
BOSS-N1 module
l.
Side wall bracket
m.
Cooling fan
n.
Air shroud
o.
Power supply units (PSU)
2. Reconnect all cables to the system board.
NOTE:
Ensure that the cables inside the system are routed along the chassis wall and secured using the cable securing
bracket.
3. Ensure that you perform the following steps:
a. Use the Easy Restore feature to restore the Service Tag. See the
feature
section.
b. If the service tag is not backed up in the backup flash device, enter the system service tag manually. See the
update the Service Tag
c. Update the BIOS and iDRAC versions.
d. Re-enable the Trusted Platform Module (TPM). See the
4. If you are not using Easy Restore, import your new or existing iDRAC Enterprise license. For more information, see the
Integrated Dell Remote Access Controller User's Guide available at https://www.dell.com/idracmanuals.
5. Follow the procedure listed in
170
Installing and removing system components
by using System Setup section.
After working inside your
Restoring the system by using the Easy Restore
Upgrading the Trusted Platform Module
system.
Manually
section.
Advertisement
Table of Contents
