Table of Contents
Advertisement
2. Follow the procedure listed in the
3.
Remove the air
shroud.
4.
NOTE:
If BOSS-N1 module is installed, ensure to disconnect the BOSS-N1 power cable and Signal cable before removing
the Riser 1 cage.
5. If applicable, disconnect the cables from the expansion card or system board.
Steps
1. Loosen the captive screws on the riser and system.
2. Press the blue release tab or blue button on the riser and holding the edges lift the expansion card riser from the riser
connector on the system board.
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 87. Removing the expansion card riser 1
128
Installing and removing system components
Before working inside your
system.
Advertisement
Table of Contents
