Table of Contents
Advertisement
Figure 121. Removing the system battery
2. To install a system battery, press the battery into the connector until it snaps into place.
3. Insert the battery in the battery holder until the battery holder clip snaps into place.
Figure 122. Installing the system battery
Next steps
1.
Install the air
shroud.
2. Follow the procedure listed in
3. Confirm that the battery is operating properly, by performing the following steps:
a. Enter the System Setup, while booting, by pressing F2.
b. Enter the correct time and date in the System Setup Time and Date fields.
c. Exit the System Setup.
d. To test the newly installed battery, remove the system from the enclosure for at least an hour.
e. Reinstall the system into the enclosure after an hour.
After working inside your
system.
Installing and removing system components
153
Advertisement
Table of Contents
