Table of Contents
Advertisement
Figure 5. Rear view of the system with 2 x 2.5-inch rear drive module
Table 5. Rear view of the system with 2 x 2.5-inch rear drive module
Item
Ports, panels, or slots
1
BOSS
2
Power supply unit (PSU1)
3
NIC ports
4
OCP NIC card
5
Dedicated iDRAC9 Ethernet
port
6
VGA port
7
Power supply unit (PSU2)
8
PCIe expansion card riser 3
(slot 3)
9
Drives
Figure 6. Rear view of the system with Direct Liquid Cooling module
Table 6. Rear view of the system with Direct Liquid Cooling module
Item
Ports, panels, or slots
1
BOSS
2
Power supply unit (PSU1)
3
NIC ports
4
OCP NIC card
12
System overview
Icon
Description
N/A
Insert BOSS blank when BOSS module is not used.
PSU1 is the primary PSU of the system.
The NIC ports that are integrated on the LOM card provide network
connectivity which is connected to the system board.
N/A
The OCP NIC card supports OCP 3.0. The NIC ports are integrated
on the OCP card which is connected to the system board.
Enables you to remotely access iDRAC. For more information,
see the Integrated Dell Remote Access Controller User's Guide at
www.dell.com/poweredgemanuals.
N/A
Enables you to connect a display device to the system.
PSU2 is the secondary PSU of the system.
N/A
The expansion card riser enables you to connect PCI Express
expansion cards. For more information , see the
installation guidelines
N/A
Enables you to install drives that are supported on your system.
Icon
Description
N/A
Insert BOSS blank when BOSS module is not used.
PSU1 is the primary PSU of the system.
N/A
The NIC ports that are integrated on the LOM card provide network
connectivity which is connected to the system board.
The OCP NIC card supports OCP 3.0. The NIC ports are integrated
on the OCP card which is connected to the system board.
section.
Expansion card
Advertisement
Table of Contents
