Table of Contents
Advertisement
3. If applicable, disconnect the cables from the expansion card.
4.
Remove the air
shroud.
5.
Remove the expansion card
Steps
1. Tilt the expansion card retention latch lock to open.
2. Pull the card holder before removing the card from the riser.
3. Hold the expansion card by the edges and pull the card from the riser.
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 99. Removing expansion card from the expansion card riser
4. If the expansion card is not going to be replaced, install a filler bracket and close the card retention latch.
riser.
Installing and removing system components
135
Advertisement
Table of Contents
