Protective Devices - Siemens SIDOOR ATD4 W Series System Manual

Appendices
A.4 Standards, directives and laws
A.4.5

Protective devices

Electrosensitive protective equipment
EN 61496-1:2013 Safety of machinery - Electrosensitive protective equipment – Part 1: General
requirements and tests, Type B standard.
This part defines the general requirements for design, production and testing of electrosensitive
protective equipment (ESPE) that is specially designed for detection of persons as part of a
safety-related system.
Pressure-sensitive protective equipment
EN ISO 13856-2:2013 Safety of machinery — Pressure-sensitive protective devices — Part 2:
General principles for the design and testing of pressure-sensitive edges and pressure-sensitive
bars, Type B2 standard
This part of ISO 13856 establishes general principles and specifies requirements for the design
and testing of pressure-sensitive edges and pressure-sensitive bars used as safeguards and not
as actuating devices for normal operation.
Note
Die EN1760-2:2001+A1:2009 has been withdrawn and replaced with ISO 13856-2:2013.
Two-hand control devices
EN 574:1996+A1:2008 Safety of machinery – Two-hand control devices – Functional aspects –
Design principles.
Chapters 6 describes the requirements for controllers
Table A-51
Use of both hands (simultaneous actuation)
Relationship between input signals and output signal
Termination of the output signal
Avoidance of unintentional operation
Preventing bypassing
Recreating the output signal
Synchronous actuation
Use of category 1 (EN 574:1996+A1:2008)
344
List of two-hand control device types and the minimum safety requirements
Requirements Section Types
I II
5.1 x x
5.2 x x
5.3 x x
5.4 x x
5.5 x x
5.6 *) x
5.7
6.2 x
ATD4xxW for industrial applications
System Manual, 06/2022, A5E51901827B AA
III
A B C
x x x
x x x
x x x
x x x
x x x
x x x
x x x
x