Table of Contents
Advertisement
•
When the front passenger sensing
system enables the front passenger
frontal airbag, the passenger airbag
status indicator illuminates the on
lamp.
If a person of adult size is sitting in the front
passenger seat, but the passenger airbag
status indicator off lamp is illuminated, it
is possible that the person is not sitting
properly in the seat. If this happens:
•
Switch your vehicle off and ask the
person to place the seat backrest in an
upright position.
•
Have the person sit upright in the seat,
centered on the seat cushion, with the
person's legs comfortably extended.
•
Restart your vehicle and have the
person remain in this position for about
two minutes. This allows the system
to detect that person and enable the
passenger frontal airbag.
•
If the indicator off lamp remains
illuminated even after this, you should
advise the person to ride in the rear
seat.
After all occupants have adjusted their
seats and put on seatbelts, it is very
important that they continue to sit upright,
leaning against the seat backrest, and
centered on the seat cushion, with their
feet comfortably extended on the floor.
Sitting improperly can increase the chance
of injury in a crash event. For example, if
an occupant slouches, lies down, turns
sideways, sits forward, leans forward or
sideways, or puts one or both feet up, the
chance of injury during a crash greatly
increases.
If you think that the state of the passenger
airbag status indicator lamp is incorrect,
check for the following:
•
Objects lodged underneath the seat.
•
Objects between the seat cushion and
the center console.
2021 Bronco (TG1) Canada/United States of America, enUSA, Edition date: 202101, First-Printing
Airbags
•
Objects hanging off the seat backrest.
•
Objects stowed in the seat backrest
map pocket.
•
Objects placed on the occupant's lap.
•
Cargo interference with the seat
•
Other passengers pushing or pulling on
the seat.
•
Rear passenger feet and knees resting
or pushing on the seat.
The listed conditions could cause the
weight of a properly seated occupant to
be incorrectly interpreted by the front
passenger sensing system. The person in
the front passenger seat could appear
heavier or lighter due to the conditions
listed.
Make sure the front passenger
sensing system is operating
properly. See Crash Sensors
E67017
and Airbag Indicator (page 66).
If the airbag readiness light is on, do the
following:
•
Pull your vehicle over.
•
Switch your vehicle off.
•
Check for any objects lodged
underneath the front passenger seat
or cargo interfering with the seat.
•
Remove the obstruction if found.
•
Restart your vehicle.
•
Wait at least two minutes and verify
that the airbag readiness light in the
instrument cluster is no longer
illuminated.
•
If the airbag readiness light in the
instrument cluster remains illuminated,
there may be a problem due to the
front passenger sensing system.
Do not attempt to repair or service the
system. Take your vehicle in for service
immediately.
64
Advertisement
Table of Contents
Troubleshooting
