Copying On Dual Drive Systems - Epson CW3S16 Operation Manual

Copying on Dual Drive Systems

To make backup copies of your MS-DOS diskettes on a dualdrive
system, follow the instructions below:
First, turn your computer on and boot up MS-DOS. Choose
the Command Prompt option from the DOS shell menu.
The system prompt will appear. Enter the following command:
This command indicates to MS-DOS that you want to, copy
the contents of a diskette in the A drive to a new diskette
located in the B drive.
The following message will be displayed:
Insert SOURCE diskette In drive A:
Insert TARGET diskette in drive B:
Press any key to continue...
The "SOURCE" diskette is the disk that you will be copying
from. The "TARGET" diskette is the one you will be copying to.
Put your master MS-DOS diskette in the A drive, and a new,
blank diskette in the B drive.
Warning!
If you have any doubts about which diskette goes in which
drive, check them carefully. Make sure that the write
protect notch on the master MS-DOS diskette is covered
with a write protect tab.
4-16 Using MS-DOS With Your Computer