Epson CW3S16 Operation Manual page 32

386 sx-BIOS (C) 1989 American Megatrends Inc.
XXXX KBOK
Press <ESC> to bypass MEMORY test
(C) American Megatrends Inc.
DNSX-6080-051690-KB
The computer continually updates this display as it tests its
memory. This test takes about 15 seconds to complete.
You may see a message similar to this:
CMOS system options not set
RUN SETUP UTILITY
P r e s s < F 1 > t o R E S U M E
This means that the computer is not yet set up for the
equipment you have installed and you must run the Setup
program, described in Chapter 2. For now, press the F1 key on
the upper left comer of the keyboard to acknowledge the
message and continue.
If you cannot see the screen display clearly, use the controls on
you monitor to adjust the brightness and contrast until
characters on the screen are clear and bright.
The computer then loads MS-DOS, the operating system, from
the hard disk into memory. MS-DOS must be in the
(C) 1990 TriGem Coporation
Setting Up Your System
1-13