Epson CW3S16 Operation Manual page 169

Diagnostics Generated Error Messages
This error message is generated by the Performance Test
procedure which requires at 'least 128KB of RAM space. So, if
your system board has less than 128KB of available RAM
space, you cannot use this function.
Controller Generated Error Messages
The controller generated error messages encountered while
performing any of the hard disk functions are displayed in a
window with 2 lines:
The actual error message could be any of the following:
Address mark not found
l
Requested sector not found (Sector not found)
l
Reset failed
l
Drive parameter activity failed
l
Bad sector flag detected
l
Bad ECC on disk read (Unrecoverable error checking and
l
correction (ECC) or cyclic redundancy check (CRC) error)
ECC corrected data error
l
Controller has failed (General controller failure)
l
Seek operation failed
l
Attachment failed to respond (Time out error)
l
Write fault on selected drive
l
Advanced ROM Diagnostics
E-4