Table of Contents
Advertisement
1) After mounting the right crank on the right shaft.
2) Alternately fasten 2 M8*P1*15 screws with an internal hex wrench. (Note: Do not fasten them from
one side at a time.) Torque is 1.5 N.m.
3) Install the left crank in the same way. (Note: Please make sure two cranks are parallel.)
6.3.8 External Speed Sensor Installation
① Model: SR SD021.01
1) Fasten the mounting screws through the speed sensor with a cross screwdriver.
2) Tighten the speed sensor onto the frame.
3) Place the rubber seal on the speed sensor hiding the screw. Torque requirement: 1.5 N.m- 2 N.m.
(Note: Place make sure the gap between the speed sensor and the magnetic unit is between 10 and 20
mm.)
10
BF-DM-C-MM G333-EN November 2019
Speed sensor
A
Magnet for the speed sensor
B
Advertisement
Table of Contents
